Cleaning a putty scraper ain't rocket science, but if you skip it, you'll end up with a gunky tool that's useless next time. Let me walk you through what I do-super simple, takes 2 minutes tops. First, if there's fresh putty, paint, or caulk on the blade?
Wipe it off right away with a paper towel or a rag. The longer that stuff dries, the harder it is to get off-I learned that the hard way when I left a scraper covered in wet putty overnight. Next morning, it was like concrete on the blade!
If the gunk's already dried? Grab a container of mineral spirits (you can get it at any hardware store for $5) and a rag. Soak the rag in mineral spirits, then rub it on the blade-this softens dried paint or putty like magic.
I once had a scraper caked in old latex paint; 30 seconds of rubbing with mineral spirits, and it came right off. For extra tough spots, let the blade soak in mineral spirits for 5 to 10 minutes-don't soak the handle though, especially if it's wood or rubber, 'cause it can ruin it.
After wiping off the gunk, rinse the blade with warm soapy water to get rid of the mineral spirits. Dry it off completely with a towel-this is key to preventing rust, especially if it's a metal scraper. I once forgot to dry mine, and a week later there were little rust spots on the blade-had to sharpen it extra to get rid of 'em.
If your scraper has a rubber handle, wipe that down with a damp rag too-no need for soap, just get rid of any dust. And that's it! A clean scraper stays sharp longer and works way better next time-no more scraping with a blade covered in old gunk.








