In the field of architectural decoration, removing old wallpaper is a common task. The Rubber Handle Wallpaper Scraper, as a practical tool, can make this job more efficient. Here are the specific methods of using the rubber - handle wallpaper scraper:
Preparation work is of great importance. Before starting to use the scraper, first cut off the power supply of the wall socket and remove the cover.
Cover the socket and switch with masking tape or plastic film to prevent water from entering and causing a short - circuit. At the same time, lay a dust - proof cloth or old newspapers on the ground to collect the falling wallpaper fragments.
If the wallpaper is peel - off type, try to gently lift a small corner of the wallpaper from the edge or corner by hand first.
For stubborn wallpaper, use the blade part of the rubber - handle wallpaper scraper. Place the scraper at an angle of about 30 degrees to the wall surface, gently insert it into the gap between the wallpaper and the wall, and then slowly and forcefully pry the scraper up or down to gradually separate the wallpaper from the wall. Pay attention to the force during operation to avoid scratching the wall.
For some firmly - pasted wallpaper, pre - treatment may be required. You can use a wallpaper steam machine or a spray bottle to evenly spray hot water or wallpaper remover on the wallpaper, making the wallpaper fully wet and softening the glue.
After the wallpaper is softened, use the rubber - handle wallpaper scraper to scrape it off. At this time, the rubber handle of the scraper can provide a good grip, allowing construction workers to operate more stably and comfortably, effectively improving work efficiency.
During the process of scraping off the wallpaper, clean the wallpaper fragments and glue residues on the scraper frequently to avoid affecting the use effect of the scraper. You can prepare a damp cloth or sponge to wipe the scraper at any time.
After most of the wallpaper has been scraped off, there may be some glue marks left on the wall. At this point, you can dip a damp cloth or sponge in an appropriate amount of detergent again, gently wipe the wall to remove the glue residues, and finally dry the wall with a clean dry cloth.
The rubber - handle wallpaper scraper plays an important role in the architectural decoration industry with its convenience and high efficiency.
Mastering the correct usage can make the wallpaper removal work smoother and lay a good foundation for the redecoration of the wall.
